4102 Auxbox Hardware

Front Panel:

Power/USB
Winks once: USB connected.
On solid: powered up, no USB.

Norstar/BCM/Meridian1
Winks once: M1/Succession.
Winks twice: BCM/Norstar.
(may be labeled TDM)

Relay 1 / 2
Active/contact closed.

Off Hook
Phone is off-hook.

MSG Wait
MWI lamp is active.

Page
Voice call or page in progress.

Rear Panel:

USB
Connect to a PC running the ALGO Recording Software.

Power 924Vdc 0.2A
Use the supplied power adapter.

Relay 1 / 2
2.5mm mono jacks, dry contact closure outputs, configured using SW2-4.

Audio
3.5mm mono jack, analog audio output.

RJ12 Jacks
Connect digital line and telephone, or connect either to a digital PBX port.

Switch Settings:

SW1	Off	On
1	Audio Level High (default)	Audio Level Low
2	Relay Options, see table.
3
4
5	Not Used.
6	Not Used.
7	1 Way Audio (RX only)	2 Way Audio (default)
8	aLaw (Europe, Austrailia)	μLaw (US) (default)

Relay Options:

2	3	4	Relay 1	Relay 2
On	On	On	Ring	Off-Hook
On	On	Off	Ring	Page
On	Off	On	Ring	MSG-Wait
On	Off	Off	Off-Hook	Page
Off	On	On	Off-Hook	MSG-Wait
Off	On	Off	Page	MSG-Wait
Off	Off	On	Off-Hook	Off-Hook
Off	Off	Off	Used During Configuration

Normal Operation:

Checking the Auxbox front panel LEDs, you should see:

Power/USB: winking to indicate USB communication with the PC.
Norstar/BCM/Meridian 1: winking to indicate PBX TN connection.
(Allow approx. 8 seconds for this to show).

Lift the telephone handset (or go off-hook with the speakerphone) and check the 'Off-Hook' LED responds. This indicates that the Auxbox is working properly.

The first time an AuxBox is connected to a PC via USB, Windows will show a 'New hardware Found' message, and automatically install the required drivers. A Windows CD may be required.

Windows should install up to 3 sets of drivers: USB Composite Device, USB Audio Device, and Human Interface Device (HID).

After the USB Audio Device drivers are installed, open the device manager and confirm a USB Auxbox is shown under the Sound category. The Auxbox will also appear in the Sound control panel.